Analysis of Heavy Metals in Roasted Meat (Suya) in Anyigba, Kogi State, Nigeria and their Health Risk Assessment
Keywords:
Roasted meat, heavy metals, tolerance limits, health risk assessmentAbstract
The aim of this work is to assess the concentration of some heavy metals in roasted meat that are sold along the road sides in Anyigba with the view of estimating their potential health risk using contamination indices. Roasted meat samples were collected from four different sample locations in Anyigba and were screened for the presence of Fe, Mg, Zn, Pb and Cd. The filtrates were analyzed for the presence of some heavy metals analysis using Atomic Absorption Spectrophotometer (AAS). The results obtained indicated that the mean concentrations of the analysed heavy metals were: 40.4 ± 0.26 -74.8 ± 0.84 mg/kg (Fe), BDL - 9.00 ± 1.20 mg/kg (Mg), 0.60 ± 0.14 - 6.80 ± 0.23 mg/kg (Zn), BDL - 2.60 ±0.65 mg/kg (Pb), BDL - 0.20 ± 0.16 mg/kg (Cd). Concentrations of Pb (1.03 ± 0.02) and Cd (0.20 ± 0.01) were above some recommended limits (EC, 2001; FAO/WHO, 2010). Also, mean concentration of Fe (46.5 ± 0.64) mg/kg was slightly above NASEM (2001) recommended limit while calculated EDI, ILCR and THI were within the permissive limit (except for the THI for Pb in adult).
Downloads
Published
Issue
Section
Most read articles by the same author(s)
- A. Yahaya, G. Ayeni, A. U. Ochala, R.A. Larayetan, A. D. Onoja, T. C. Omale, J. A. Akor, Evaluation of mineral in the indigenous and industrially produced soya milk in the Anyigba, Kogi State , Communication In Physical Sciences: Vol. 6 No. 1 (2020): VOLUME 6 ISSUE 1
Similar Articles
- Hassan Abdulsalam, Dr Fatima Musa Lariski, Effect of Cerium on the Dielectric and structural Properties of Barium Titanate-based ceramics for multilayer ceramic capacitors , Communication In Physical Sciences: Vol. 12 No. 5 (2025): Vol 12 ISSUE 5
- David Adetunji Ademilua, Cloud Security in the Era of Big Data and IoT: A Review of Emerging Risks and Protective Technologies , Communication In Physical Sciences: Vol. 7 No. 4 (2021): VOLUME 7 ISSUE 4
You may also start an advanced similarity search for this article.



